Spilit Audio

1. Select an audio file in the Player interface and click the Splitter button to get to the splitter. If you forget to select a file, you will not be able to enter the Splitter.
2. The selected file will be displayed in the file list on the Splitter interface.
3. Play the audio file. When the slider on the process bar goes to the point you need to split, click Add time button. You can also drag the slider to the point and click Add time. The action will increase a pre-split segment.
4. Click each segment in the file list you will see the corresponding section highlighted in the process bar.
5. If you don't need a certain segment, select it from the file list or process bar then click Remove. The command Remove all will clear all the segments from both the file list and the process bar. Such action will not delete the original audio file however.
6. Select a segment in the file list and click Preview. The selected segment will be played. Previewing is not the same as playing. Playing means going through the whole process of the track, while previewing means going through the selected section only. So when you want to test a segment, you may preview it.
7. The Goto button is good for quick locating the slider. Key in a definite time in the blanks and click Goto.
8. Click the arrow button to make minor adjustment of the slider. Each click will make the slider go forward or backward by 0.048 seconds.
9. After all segments prepared, check to select the ones you need. Click Start splitting to begin splitting. The split files will be saved in the default output path.
10. If you want to change the output path or way of naming, go to Options->Save->Splitter.